News

Swing Up Jockey Wheel in blog news

Position the trailer on a stable and LEVEL working surface. If possible, leave the tow vehicle hooked to the trailer in order to limit movement as well as keeping the front end supported and level. If the trailer is not supported on the tow vehicle, it MUST be blocked directly to the ground at the frame/tongue junction. UNDER NO CIRCUMSTANCES IS THE TRAILER TO BE SUPPORTED BY THE TONGUE JACK WHILE BEING RAISED AT THE WHEELS! Block the wheels opposite the side being worked on both front and rear so that the trailer cannot roll. NOTE: Using an adequate capacity...

  1. Tack your middle Hanger. 2. Pull your front and rear Hangers out as far as they will go (ensuring the middle Rocker is kept level). 3. Tack the front and back Hanger. 4. Unless you specify the size of the wheels you are using, your springs will come to you as 13" - 15" setting by default. 5. If you need to convert this to the 4WD 15" - 16" setup, simply unbolt the springs and swap the front spring for the rear. 6. This will spread your bolts further apart.   Note: These instructions are the correct...